Vent Trim Blackout Kit for the 2024+ Tacoma & 2025+ 4Runner
Black out every A/C vent surround on the dash with one 3-piece kit - a simple interior upgrade that makes a big difference.
Only need part of the dash? The pieces are also sold separately: the 1-piece center overlay or the 2-piece side overlays. The kit includes all three and costs less than buying them individually.
One Kit, a Fully Blacked-Out Dash
The center and side vents frame the whole dashboard, and the factory finish on them blends into the plastic around it. This kit turns all three surrounds black, adding contrast against the screen and giving the interior a clean, custom look.
The pieces sit over the factory trim, so the original design stays intact: no cutting, no wiring, no permanent changes to the dash.
Built from Tough ABS
All three pieces are injection molded from high-strength, impact-resistant ABS plastic, so they hold their shape and fit through heat, cold and daily use. They attach with automotive VHB tape for a strong, clean bond.
For the best result, install while the vehicle interior is between 70 and 100 degrees F.
Before & After
Installed on the Dash
Easy Installation
Clean each vent surround, test fit the pieces, remove the tape backing and press each one firmly into place. Install with the interior between 70 and 100 degrees F. If you have trouble with the center piece, jump to about 3:11 in the first video.
Center, left and right A/C vent trim - sold as a 3-piece kit
Shipping & Returns: Backed by our 30-day return policy. Made in the USA with the 3M VHB tape ready to go. Not sponsored by or affiliated with Toyota.
FAQ
Will this fit my 4Runner as well as my Tacoma? Yes. These overlays are made for the dashboard air vents on both the 2024+ Tacoma and the 2025+ 4Runner. The install photos on this page show a Tacoma.
What is in the kit? One center vent trim piece and two side vent trim pieces, all in black ABS, with VHB tape for installation.
What temperature should I install it in? Install with the vehicle interior between 70 and 100 degrees F so the VHB tape bonds properly.
What is it made of? Injection-molded, high-strength and impact-resistant ABS plastic in black.
Can I buy the pieces separately? Yes. The center piece and the side pieces are each sold on their own, but the kit costs less than buying all three.
Is it affiliated with Toyota? No. This is an aftermarket accessory made by AJT Design and is not sponsored by or affiliated with Toyota.
