Earn [points_amount] when you buy this item.
Couldn't load pickup availability
This freedom flag theme is a popular choice for off-road vehicles. It was requested by one of our customers. The sun visors come with labels that detract from the interior design of the vehicle. This is the perfect solution to dress them up. Visible from the inside when they're stored and the outside when they're in use.
By purchasing this product, and covering up your labels, you agree to commit those labels to memory and no longer require them.
Currently fits ALL 2021+ Broncos.
While StickerFab caters to a large number of people, it is still possible to customize some orders. Ideas that have broad appeal are the best! However, if you have some art work, we may be able to do a special print just for you.
Please refrain from submitting trademarked content unless you have the rights to it. We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.
Use our contact form to get in touch with us.
See the overview / install video above. NOTE: All topo vinyls are shipped in tubes to prevent damage. Prior to install, lay out all of these items and make sure they are flat prior to install.
You will want to do this in 70-80 degree weather ideally. Stay in the shade unless it is a little on the cool side.
Recommended items:
Very easy to install and looks great. I had a lot of comments on where did I get them
We all hate those bright yellow and white safety warning decals that the manufacture must place on the sunvisors and stand out like a sore thumb whenever the visors are down. Does anyone even know what they say? Probably not. The printed vinyl overlay is the perfect solution and were extremely easy to install in just a few minutes. The overlays are cut perfect for an exact fit so no trimming is required. All I did was clean the visor thoroughly with isopropyl alcohol on the side the overlay was to be applied and dried with a soft cloth. Next was to mix a small amount of water with a few drops of baby shampoo in a spray bottle to soak the adhesive side of the overlay as I released it from its paper backing. It doesn't hurt to give the visor a spray also. Place the overlay on the visor surface while lining up the edges with the general shape of the visor. The slight soapy water solution will allow you to move the overlay around while lining up perfectly. Next squeegee the water out from underneath with a credit card or similar thin item wrapped once in a paper towel. Start in the center and work toward the edges. The paper towel will soak up the excess water as it is pushed out of the vinyl so rotate the paper to a new dry spot with each pass. A hair dryer set on low heat will help the edges lay down if you are applying in lower temps. The resulting finished product looks great.
