Low cost customization
Easy to install
Installation video below

Smoked Sidemarker Overlays (Front Only)

When you're trying to achieve a certain theme, sidemarkers can stick out like a sore thumb. There's an easy way to make them less noticeable (light can still pass through at night), without spending a lot of money. That smoked look is achievable through vinyl.

We provide a variety of materials you can get these in. Start a theme for your vehicle and mix it with our other vinyl products.

Sold as a pair (left and right).

AVAILABLE MATERIALS

Dark Smoke - Standard dark smoke material. Made in Germany.
Dark Smoke LX+ - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
Light Smoke - Standard dark smoke material. Made in Germany.
Light Smoke LX+ - Premium light smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
Dark Smoke Stealth - Premium matte dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
Light Smoke Stealth - Premium matte light smoke material with air egress channels for ease of installation (helps prevents bubbles). Made in the USA.
Dark Smoke Honeycomb - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
Dark Smoke Carbon Fiber - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). Modified light pattern when lit. Made in the USA.
Dark Smoke Galaxy - Premium dark smoke material with air egress channels for ease of installation (helps prevents bubbles). A galaxy full of metallic flake in the light. Appears similar to standard dark smoke when backlit. Made in the USA.

Instructions

Items you may want to have:

Detail Spray (without wax) or glass cleaner
Microfiber Towel or Paper Towel
StickerFab Application Fluid or dish with soapy water (few drops of dish soap + 1-2 cups of water)
Felt Lined Squeegee(optional)
Heat gun or hair dryer (optional)

Clean the application area to prepare it for installation. Do not use a spray with any type of wax in it.

The overlays are labeled on the back. Installation video is for front and rear, but this listing is for FRONT only. Similar product application.

A wet installation is recommended. Use slightly soapy water on the back of the vinyl. This will allow you to move the vinyl around and find the correct alignment. Once aligned, use your fingers or a felt tip squeegee to push out the water/air. Allow the vinyl to dry. Once dry, make sure all the edges are adhering to the sidemarker. If they are not sticking very well, apply LIGHT heat and press them down again.

2021+ Bronco Exterior Vinyl

Currency