Earn 192 Points when you buy this item.
This is inspired by some First Edition decals that Toyota showed off on their vehicle. Photos available on international sites to include the UK. Show off your First Edition with pride. Add this little touch to the rear fenders of your vehicle.
We have the ability to print just about any designs on our Roland machines. Please contact us if you have any ideas for new variants.
INSTALLATION
View video above and read this section as well. Desired installation temperature is above 70 degrees. Clean the install area with a wax free cleaner and microfiber cloth.
Wet install the template along the side of the fuel door and below the fender edge on the driver's side. Use StickerFab Application Fluid or soapy water so you can slide the template around.
On the passenger side, measure back 20 5/8" from the rear door gap, and place the template there.
Remove the sticker from the backing paper using the pre-installed grid transfer paper. Align the letters just inside the template and place the vinyl. Push down in the middle and then press from the center to one side. Go back to the center and push down to the opposite side. Then firmly press down each letter before removing the transfer video.
Notice of Non-Affiliation and Disclaimer:
StickerFab is not affiliated, associated, authorized, endorsed by, or in any way officially connected with Toyota, or any of its subsidiaries or its affiliates.
The name Prado as well as related names, marks, emblems and images are registered trademarks of their respective owners, including Toyota.
