Earn [points_amount] when you buy this item.
Couldn't load pickup availability
These projectors have a big impact when getting in and out of your vehicle at night. You can choose between changing out just the front doors, rear doors, or grab one set for each pair of doors.
These are designed as an OE style replacement with an OE style projection design. They snap into place like the factory housings and utilize the factory plug.
NOTE: Rear door has a small cut off at the top of the circle as seen in photos.
Use a flat trim tool and insert it between the trim and the factory lamp. Remove the lamp. The front and rear lamps are actually the same housing. The projector angle can be changed by rotating the barrel.
Unplug the factory lamp from the factory harness. When plugging it into the new lamp, See our photos to understand which hole the prongs go into for the new housing. If you need to adjust the angle of the prongs, you can do by popping the PCB out gently and using your fingers to move them. Then pop them back into the housing. If you are careful when plugging these in, no adjustments should be required.
Test the lamp and then pop it back into the plastic trim. Alignment issues with your factory doors and trim could cause the projector to get hung up. Please contact us if you run into any issues, and we can help you work through them.
