3D Carbon Fiber Rear Fog / F1 Bumper Cover Overlay - 2015-2021 WRX / STI
€12,95 EUR
Earn [points_amount] when you buy this item.
Couldn't load pickup availability
Earn [points_amount] when you buy this item.
Couldn't load pickup availability
There is a unique feature on the center of your rear bumper. Why not bring more attention to it? Whether you have the factory cover or a rear fog light / F1 lamp, you add a little style to this area with this overlay.
Perhaps you slightly scratched this area during an install. The overlay should cover that blemish right up.
Comes with 3 pieces. This multi piece install allows you to contour normally difficult areas with ease.
CUSTOMER MESSAGE - "Got them just now, thanks for including a(n) extra set! I've had 2 sets of CF look ones from another seller and silver stars kept peeling and the carbon look faded really bad."
When purchasing vinyl overlays, keep in mind that not all materials are created equally. I use premium vinyl which has high initial costs, but are the industry standards for high quality materials. Also made in the USA. - Dragon Wrap™ Carbon Fiber Films (3D Carbon) is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. - This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application. - Minimum application temperature is 40 degrees Fahrenheit. - Up to 5 year durability outdoors. Rated EXCELLENT for WATER RESISTANCE, HUMIDITY RESISTANCE, and SOLVENT RESISTANCE.
Clean the area of application. Make sure it is free of any wax or Armor All. Align the top of the large piece right below the painted portion of your bumper.
Use only your fingers to push down the vinyl and make sure it is being guided to the right areas. The material can stretch a little bit. Use your fingernails to tuck any vinyl hanging over the center of the trim around the edges.
Now match the weave of the larger piece with the smaller side pieces. Apply each one individually to cover up the remaining portions of trim.