3D Carbon Phone Charger / USB / Cigarette Lighter Tray Overlay - 2020+ Supra
$36.00 AUD
Earn 112 Points when you buy this item.
Earn 112 Points when you buy this item.
Sticker Fab has produced a number of 3D Carbon vinyl overlays for the interior of the GR Supra. These usually cover areas that are prone to scratching and/or just very plain. The overlays are an easy and affordable way to add some customization to your vehicle. These mods are easy to remove should you ever change your mind or trade in your vehicle.
NOTE: Fits wireless and non-wireless charger equipped vehicles. Designed for LHD vehicles. Please message to make an inquiry about RHD vehicles.
Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. Initial alignment is the key to proper installation. We recommend sitting in the passenger seat and starting with the upper right corner. Gently lay it down and work your way downwards first. Continue over to the left side along the bottom. If these areas aren't aligning you need to start over again. You can gently guide the material as you lay it down up to a certain extent. Don't apply too much pressure though. While forgiving, you don't want to stretch the material too much.
After everything is down and aligned properly, we recommend that you have a hair dryer or heat gun around to encourage the vinyl to stick.
Squeegees are not recommended and not needed. Material is pressure activated so continue to press down areas that are not adhering on the first pass.