Special Edition Dark Smoke Carbon Fiber Headlight Overlays - 2015-2020 WRX / STI
$107.00 AUD
Earn [points_amount] when you buy this item.
Couldn't load pickup availability
Earn [points_amount] when you buy this item.
Couldn't load pickup availability
This material is not cheap! It's made with pride in the USA and then trimmed down in the USA to fit your vehicle.
It does allow light to pass through while still giving you that dark carbon look. If carbon fits your theme, you should take a serious look at this mod.
They're easy to install and can surprisingly transform the look of your vehicle.
NOTE: Install item of interest photos are listed last.
Clean and wet the surface of the overlay and the headlight using of a mixture of soap (1 drop of dishwasher soap) and water. This will help you align the piece. Place it in the appropriate area and squeegee the water out with your fingers. This will prevent damage to the surface of the overlay when you use just your fingers. You can use your nails to make sure any portion overlapping the edges sticks to the edges.
It is recommended to use a heat gun (low setting) or hair dryer to increase the adhesion of the vinyl. The soapy water decreased the adhesion so you could align it correctly. The heat will help dry out that water. For the edges, it can help you wrap the material around those edges and adhere to tougher bends at the edges.
Allow 24 hours for the overlay to fully stick to the headlight. Once completely dry, they will hold up in automatic car washes and against most power washing.
I love the way these look on the car! They were simple to install but came with zero instructions. I searched youtube to find videos on how to install them and the installation was very simple. There was no information on cure time or anything like that. I installed mine using a heat gun and soapy water and let the car sit in the garage for a day because it started raining and hit it lightly with the heat gun again. The second trip out was a downpour of rain and the passenger side came off. I contacted support and they allowed me to purchase just the lost overlay and gave me advise on cure time. Customer support has been great with StickerFab for me! And I really like the products. note the finished picture is showing a reflection from an orange bucket in the background.
