OLM OE Plus Linear Style Sequential Tail Light Overlays (Dark, Light, Red, or Yellow) - 2017-2021 Toyota 86 / Subaru BRZ
77.00 SAR
Earn 101 Points when you buy this item.
Earn 101 Points when you buy this item.
NOTE: This is an overlay and we am not selling tail lights. These cover the center of the lamp. Available in dark smoke, light smoke, red, and yellow. Special Edition material are available in another listing.
Vinyl can really change the look of your vehicle. You can tastefully take your vehicle to looking stock to not without breaking the bank. Style your OEM tail lights by installing these tail light overlays.
Comes with a pair of overlays (left / right). Please look at the pictures closely to see how they are installed and follow the instructions below. Dark smoke is what is seen in the pictures. Light smoke is about half the darkness of this.
Difficulty 3.5 of 5
Recommended Tool(s): Heat Gun or Hair Dryer, soapy water
Clean the surface of the tail light. Use soapy water to make installation easier. Place the slightly soapy water on the tail light and the adhesive side of the overlay. Start in the middle of the tail light and apply the film. Use your fingers to squeegee out the water. It is recommended you use your fingers so you do not scratch the material. The heat can be used to allow the material to stretch AND to slightly shrink it when you're not pulling it. Massage out any creases with your fingers. You may have to pull up sections and reapply if many creases begin to appear. Keep working the material until you have 100% coverage. Average time per install is 10 minutes per side. Best to allow the vehicle to remain in the sun for some time and DO NOT POWER WASH for at least 48 hours. Some bubbles and creases may disappear over time and exposure to heat.
Please check out the FTSpeed video on this installation. If you're an FTSpeed customer, try adding this item to your cart there and check out the other items they offer!