Plug and play
Easy to install
"Land Cruiser" Logo
Intensity level - standard

OSD 2024 "Land Cruiser" Door Welcome Light / Projectors

These projectors have a big impact when getting in and out of your vehicle at night. You can choose between changing out just the front doors, rear doors, or grab one set for each pair of doors.

These are designed as an OE style replacement. They snap into place like the factory housings and utilize the factory plug.

NOTE: The intensity level of these are standard vs the install video which were high intensity lamps. The plugs on this model are on the back of the unit vs the original.

Installation

Use a flat trim tool and insert it between the trim and the factory lamp. Remove the lamp. The front and rear lamps are actually the same housing. The projector angle can be changed by rotating the barrel.

Unplug the factory lamp from the factory harness. When plugging it into the new lamp, See our photos to understand which hole the prongs go into for the new housing. If you need to adjust the angle of the prongs, you can do by popping the PCB out gently and using your fingers to move them. Then pop them back into the housing. If you are careful when plugging these in, no adjustments should be required.

Test the lamp and then pop it back into the plastic trim. Alignment issues with your factory doors and trim could cause the projector to get hung up. Please contact us if you run into any issues, and we can help you work through them.

OSD

Currency