Couldn't load pickup availability
Here's our second series of designs we are rolling out. These printed B pillar overlay photos do not do them justice. In person these look great! I can't believe we didn't make them sooner. They blend in really well with our printed series fender overlays as well.
It's easy to install and can cover up minor imperfections and discolorations in the B pillar.
Fits ALL 4 door 2021+ Broncos. Matte finish.
2 pieces:
While StickerFab caters to a large number of people, it is still possible to customize some orders. Ideas that have broad appeal are the best! However, if you have some art work, we may be able to do a special print just for you.
Please refrain from submitting trademarked content unless you have the rights to it. We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.
Use our contact form to get in touch with us.
Use the following video and written instructions to complete the install.
You will want to do this in 80-85 degree weather ideally. Stay in the shade unless it is a little on the cool side.
Recommended items:
We recommend doing this after a fresh car wash. Re-clean the application area to prepare it for installation. Just use a wax free detailing spray if your vehicle is not too dirty. Do not forget to clean the edges of the B pillar. Also wash your hands. You do not want to get dirt stuck to the adhesive side of the material. You can use an alcohol wipe on the edges. Note if the wipe is still dirty after use and use more if needed. Allow area to dry.
Prep both sides. Then use the 3M adhesive promoter on the edges of the pillar. It dries out quickly so you need to do both sides within a few minutes. The promoter is required as the pillar is textured and the curved edges need this preparation for the vinyl to stick properly. Allow time to dry.
Do a DRY INSTALL, but be careful not to crease the vinyl. This material is pretty forgiving if installed under the right temperatures. Align the vinyl along the top and lead edge. Then push out the air carefully as to prevent creasing. You can also use a combination of your hands and the felt tip squeegee.
The adhesive reacts to PRESSSURE and HEAT.
Due to the size of the pillar, the design was done vertically. When hanging a flag vertically the star field is always to the left.
Very easy to put on !
I like the look of the product, the weight and quality of the sticker material is fantastic.....the edges at the corners are a little tough to get to stay down...I am hoping this will not be an issue to come with the possibility of it peeling up or otherwise getting caught. Overall, so far, a great product, coverage is good, protects the Pillar really well and I am very pleased.
Another amazing product. Like the other review, I watched Chris’ install video a few times and went back and forth on went install or not. Glad I didn’t do the wet install as it was pretty easy and the vinyl is very forgiving. My kids said “those look awesome” and that’s all I need haha. I thankfully read David’s review regarding the primer pen and went quick on the first side so I had enough but can easily see how you can run out on the first side as it does come out fast.
Flags are awesome! I have gotten a lot of comments about how great they look on my 4 door Bronco. Very easy to install. I did watch the installation video 2 times. Only thing I suggest is that 2 of the adhesive applicators are included, one for each side. The applicator is hard to control how much comes out and I used most of it on the first application leaving very little for the second application. Otherwise, I am extremely pleased.
