Subtle change with big impact
Easy to apply (ships with a backup piece)
Fits ALL 2024+ Land Cruiser / GX550 / 2025+ 4Runner

Third Brake Light Overlay

2024+ Toyota Land Cruiser / Lexus GX 550 / 2025+ Toyota 4Runner

Not many small vinyl shops have print capabilities. This allows us to make some pretty unique designs. This product is printed on clear vinyl and just one piece. No cut outs for the letters. Nothing to snag when drying off your vehicle. Easier to install.

It blocks enough light so that you can see the design yet doesn't block so much that it makes braking unsafe.

Fits ALL 2024+ Land Cruisers / GX550. Gloss finish.

Features

TruProtect - UV Resistant Laminate
TruPrint - Authentic Roland inks and printers
Made in the USA

Customization

While StickerFab caters to a large number of people, it is still possible to customize some orders. Ideas that have broad appeal are the best! However, if you have some art work, we may be able to do a special print just for you.

Military Themed
Patriotic
Other organizations

Please refrain from submitting trademarked content unless you have the rights to it. We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.

Use our contact form to get in touch with us.

INSTALLATION

You will want to do this in 70-85 degree weather ideally. Stay in the shade unless it is a little on the cool side. Make sure the vinyl is flat before installation.

Recommended items:

Microfiber
Detailer spray to prep the area (without wax)
StickerFab application fluid
Optional Heat gun or hair dryer

Clean the application area to prepare it for installation. Just use a wax free detailing spray if your vehicle is not too dirty. Do not forget to clean the edges of the trim. Also wash your hands. You do not want to get dirt stuck to the adhesive side of the material. Allow area to dry.

If you do not consider yourself an AWESOME installer, do a wet install. Wet your fingers, the back of the vinyl and the trim with our StickerFab application fluid. In a pinch you can use 1 drop of dish soap mixed with 1 cup of water. Align triangle and gently push out the water under it. When dry, check final install to verify alignment. If you need to re-do it, use your backup piece. To speed up the drying process you can use a heat gun or hair dryer. Apply very low heat as to not damage the vinyl.

For a dry install, this material is pretty forgiving if installed under the right temperatures. Align the vinyl. Then push out the air carefully as to prevent creasing. Just use your fingers as the piece is small.

The adhesive reacts to PRESSSURE and HEAT.

2024+ Land Cruiser Best Sellers

Currency