Additional protection
Beautifully designed
Easy to apply
Includes 3M adhesive promoter (newer material does not require this)
Fits ALL 2/4 door 2021+ Broncos

2021+ Bronco B Pillar Protection

These printed B pillar overlay photos do not do them justice. In person these look great! I can't believe we didn't make them sooner. They blend in really well with our printed series fender overlays as well.

It's easy to install and can cover up minor imperfections and discolorations in the B pillar.

Fits ALL 2/4 door 2021+ Broncos. Matte finish.

2 pieces:

Left Pillar
Right Pillar

Customization

While StickerFab caters to a large number of people, it is still possible to customize some orders. Ideas that have broad appeal are the best! However, if you have some art work, we may be able to do a special print just for you.

Military Themed
Patriotic
Other organizations

Please refrain from submitting trademarked content unless you have the rights to it. We are located in Fort Myers, FL if you are interested in helping us create custom templates for other vehicles or trim levels.

Use our contact form to get in touch with us.

INSTALLATION

Use the following video and written instructions to complete the install. NOTE: All topo vinyls are shipped in tubes to prevent damage. Prior to install, lay out all of these items and make sure they are flat prior to install.

You will want to do this in 80-85 degree weather ideally. Stay in the shade unless it is a little on the cool side.

Recommended items:

This Kit (overlays + 3M promoter stick)
Optional Squegee
Microfiber
Detailer spray to prep the area (without wax)
Alcohol wipe
Optional Heat gun or hair dryer

We recommend doing this after a fresh car wash. Re-clean the application area to prepare it for installation. Just use a wax free detailing spray if your vehicle is not too dirty. Do not forget to clean the edges of the B pillar. Also wash your hands. You do not want to get dirt stuck to the adhesive side of the material. You can use an alcohol wipe on the edges. Note if the wipe is still dirty after use and use more if needed. Allow area to dry.

Prep both sides. Then use the 3M adhesive promoter on the edges of the pillar. It dries out quickly so you need to do both sides within a few minutes. The promoter is required as the pillar is textured and the curved edges need this preparation for the vinyl to stick properly. Allow time to dry.

Do a DRY INSTALL, but be careful not to crease the vinyl. This material is pretty forgiving if installed under the right temperatures. Align the vinyl along the top and lead edge. Then push out the air carefully as to prevent creasing. You can also use a combination of your hands and the felt tip squeegee.

The adhesive reacts to PRESSSURE and HEAT.

2021+ Bronco Best Selling Aftermarket Products (Top 50)

Currency